2 Functions of Devices in DVP-PLC DVP-PLC Application Manual 2-27 Flag Function M1279 Internal control signal input point of HHSC3 start signal point (S) M1289 High speed counter I010 interruption forbidden M1290 High speed counter I020 interruption forbidden M1291 High speed counter I030 interruption forbidden M1292 High speed counter I040 interruption forbidden M1293 High speed counter I050 interruption forbidden M1294 High speed counter I060 interruption forbidden M1312 C235 Start input point control (not supported by EH3/SV2) M1313 C236 Start input point control (not supported by EH3/SV2) M1314 C237 Start input point control (not supported by EH3/SV2) M1315 C238 Start input point control (not supported by EH3/SV2) M1316 C239 Start input point control (not supported by EH3/SV2) M1317 C240 Start input point control (not supported by EH3/SV2) M1320 C235 Reset input point control (not supported by EH3/SV2) M1321 C236 Reset input point control (not supported by EH3/SV2) M1322 C237 Reset input point control (not supported by EH3/SV2) M1323 C238 Reset input point control (not supported by EH3/SV2) M1324 C239 Reset input point control (not supported by EH3/SV2) M1325 C240 Reset input point control (not supported by EH3/SV2) M1328 Enable Start/Reset of C235 (not supported by EH3/SV2) M1329 Enable Start/Reset of C236 (not supported by EH3/SV2) M1330 Enable Start/Reset of C237 (not supported by EH3/SV2) M1331 Enable Start/Reset of C238 (not supported by EH3/SV2) M1332 Enable Start/Reset of C239 (not supported by EH3/SV2) M1333 Enable Start/Reset of C240 (not supported by EH3/SV2) D1022 Multiplied frequency of A-B phase counters for ES/EX/SS and SA/SX/SC series MPU D1150 Table counting register for DHSZ multiple set values comparison mode D1151 Register for DHSZ instruction frequency control mode (counting by table) D1152 (low word) D1153 (high word) In frequency control mode, DHSZ reads the upper and lower limits in the table counting register D1153 and D1152.
D1166 Switching between rising/falling edge counting modes of X10 (for SC V1.4 _ series MPU only) D1167 Switching between rising/falling edge counting modes of X11 (for SC V1.4 _ series MPU only) D1225 The counting mode of the 1st group counters (C241, C246, C251) D1226 The counting mode of the 2nd group counters (C242, C247, C252) D1227 The counting mode of the 3rd group counters (C243, C248, C253) D1228 The counting mode of the 4th group counters (C244, C249, C254)