9 Application Instructions API 150-199 D1222: Time difference between the direction signal and pulse output of CH0 D1223: Time difference between the direction signal and pulse output of CH1 D1240: Low 16 bytes of the setting value for the end frequency of the high-speed output CH0 (available when the acceleration and deceleration are separate) (If D1240 D1241: High 16 bytes of the setting value for the end frequency of the high-speed output CH0 (available when the acceleration and deceleration are separate) (If D1240 adopted.) D1244: Number of idle speed output from CH0 (> 0: Effective vale; D1245: Number of idle speed output from CH1 (> 0: Effective vale; D1247:
Number of idle speed output from CH3 (> 0: Effective vale; D1246: Number of idle speed output from CH2 (> 0: Effective vale; D1383: Time difference between the direction signal and pulse output of CH2 D1384: Time difference between the direction signal and pulse output of CH3 D1336: Low word of the current number of output pulses of CH0 D1337: High word of the current number of output pulses of CH0 D1338: Low word of the current number of output pulses of CH1 D1339: High word of the current number of output pulses of CH1 D1375: Low word of the current number of output pulses of CH2 D1376: High word of the current number of output pulses of CH2 D1377:
Low word of the current number of output pulses of CH3 D1378: High word of the current number of output pulses of CH3 D1340: Start/end frequency settings of CH0 (default: K200) D1352: Start/end frequency settings of CH1 (default: K200) D1379: Start/end frequency settings of CH2 (default: K200) D1380: Start/end frequency settings of CH3 (default: K200) D1348: Deceleration time of CH0 pulse output when M1534 = On (default: K100) D1349: Deceleration time of CH1 pulse output when M1535 = On (default: K100) D1350: Deceleration time of CH2 pulse output when M1536 = On (default: K100) D1351: Deceleration time of CH3 pulse output when M1537 = On (default: K100) D1343:
Acceleration/deceleration time of CH0 pulse output (default: K100) D1353: Acceleration/deceleration time of CH1 pulse output (default: K100) D1381: Acceleration/deceleration time of CH2 pulse output (default: K100) D1382: Acceleration/deceleration time of CH3 pulse output (default: K100) D1478: Close loop output/input ratio of CH2 (default: K100) D1479: Close loop output/input ratio of CH3 (default: K100) DVP-PLC Application Manual 9-139