10 Application Instructions API 202-313 API 287~ 292 Operands: S 1 : Source device 1 S 2 : Source device 2 Explanations: 1. EH2/SV_V1.9 and versions above, and EH3/SV2 supports the function. EH series does not support the dunction. 2. This instruction compares the content in S 1 and S 2 . Take API287 (FOR =) for example, if the result is “=”, the continuity of the instruction is enabled. If the result is “≠”, the continuity of the instruction is disabled 3. The user can specify the floating point value directly into operands S 1 and S 2 (e.g. F1.2) or store the floating 4. OR ※ ( ※ : =, >, , ≤, ≥) instruction is used for parallel connection with contacts.
point value in D registers for further operation. Program Example: When both X2 and M30 are OFF and the content in D100 (D101) ≥ F1.234, M60 = ON. X2 M30 M60 DVP-PLC Application Manual 10-32 Mnemonic Operands Function FOR※ Floating Point Parallel Type Comparison Type OP Bit Devices Word devices Program Steps X Y M S K H KnX KnY KnM KnS T C D E F FOR※: 9 steps S 1 * * * S 2 * * * PULSE 16-bit 32-bit SA SX SC EH SV EH3 SV2 ES EX SS SA SX SC EH SV EH3 SV2 ES EX SS SA SX SC EH3 ES EX SS EH SV SV2 API No.
32-bit instruction Continuity condition Discontinuity condition 287 FOR＝ S ＝S 1 2 S ≠S 1 2 288 FOR＞ S ＞S 1 2 S ≦S 1 2 289 FOR＜ S ＜S 1 2 S ≧S 1 2 290 FOR＜＞ S ≠S 1 2 S ＝S 1 2 291 FOR＜＝ S ≦S 1 2 S ＞S 1 2 292 FOR＞＝ S ≧S 1 2 S ＜S 1 2 FOR>= D100 F1.234