DVP201/202/211LC-SL Load Cell Module Operation Manual 3.1 Installation 3.1.1 Connecting a Load Cell Module to a DVP-SV series PLC Pull the I/O module clips on a DVP-SV series PLC. Insert the points in the corner of a load cell module into the four holes in the DVP-SV series PLC. Please see step in the figure below. Press the I/O module clips on the DVP-SV series PLC, and make sure that the load cell module is tightly connected to the DVP-SV series PLC. Please see step in the figure below. 2 DVP211LC DV P28SV - 1 RUN STOP 2 3.1.2 Installing a DVP-SV series PLC and a Load Cell Module on a DIN rail Please use a 35 mm DIN rail.
Pull the DIN rail clips on a DVP-SV series PLC and a load cell module. Install the DVP-SV series PLC and the load cell module on the DIN rail. Press the DIN rail clips on the DVP-SV series PLC. Please see the figure below. 35 mm DIN rail 3-2 DV P211L C 35