CANopen Communication Module DVPCOPM-SL Note: l Use slotted screwdriver to adjust the DIP switch carefully in case you scratch the switch. l Please set up the function switch when the power is switched off. After the setup is completed, re-power DVPCOPM-SL. 2.6 Digital Indicator The digital indicator provides the following two functions: l Displaying the node address of DVPCOPM-SL. l Displaying the error message of slave. 3 Basic Operation 3.1 Connecting DVPCOPM-SL to DVP-SV MPU l Open the fixing clip on top and bottom of DVP-SV. Meet the extension port of DVPCOPM-SL with DVP-SV, as j . l Press the fixing clips on top and bottom of DVP-SV and check is the connection is fine, as k .
2 DVP28SV 1 RUN STOP 2 3.2 Installing DVPCOPM-SL and DVP-SV MPU on DIN Rail l Use 35mm DIN rail l Open the DIN rail clip on DVP-SV and DVPCOPM-SL. Insert DVP-SV and DVPCOPM-SL onto the DIN rail. l Clip up the DIN rail clips on DVP-SV and DVPCOPM-SL to fix DVP-SV and DVPCOPM-SL on the DIN rail, as shown below. 35mm DIN rail DVP-PLC Application Manual 7 DVPCOPM POWE R R UN ER R ADDRESS NODE x161 x160 DR 2 DDRR 10 IN 0 CAN+ SHLD CAN- GND DVPCOPM POWER R UN ER R ADDRESS NODE DVP28SV x161 x160 DR 2 DR 1 DR 0 IN 0 CAN+ RUN SHLD CAN- STOP GND 35