DeviceNet Network Scanner DVPDNET-SL 4.1.2 Setup of Scan Module The following dialog is for setting DVPDNET-SL’s current mode: master mode or slave mode. Note: These parameters and the configuration information are downloaded to DVPDNET-SL together. DVP-PLC Operation Manual 9 Parameter Explanation Master mode For setting DVPDNET-SL as master mode. Scan interval time The cycle time for master to send and receive the real time data after real-time data connection is successful. Timeouts （EPR） The result value of the parameter multiplied by 4. (Unit:ms) Master assumes that the slave is offline if it receives no response from slave after timeout.
Extended baud rate The parameter gets effective only in master mode. Selecting “Startup” activates the function of extended baud rate. Select the appropriate baud rate according to actual demand then. Slave mode For setting DVPDNET-SL as slave mode Bit-strobe Reserved; no actual purpose now. Polled The parameters get effective only in slave mode. The filled byte number corresponds to the data length for output and input as DVPDNET-S is taken as slave. “Sending data length” corresponds to “Output length” and “Receiving data length” corresponds to “Input length”. COS/CC Reserved; no actual purpose now. Device mapping address For AH modes specially; no actual purpose now.