DeviceNet Network Scanner DVPDNET-SL 9.2 Setup of Extended Baud Rate (as slave mode) 1) Connect the relevant devices to the DeviceNet network according to the following figure. DVP28SV DVPDNET-SL(Master) DeviceNet Builder DeviceNet DVP28SV DVPDNET-SL(Slave) Note: a. DVPDNET-SL at the bottom of the above figure has been set as slave mode. b. The node addresses of two DVPDNET-SLs must not be repeated. (See section 2.4). c. The baud rates of two DVPDNET-SLs are both 500K bps (See section 2.5 ） . 2) Open DeviceNet Builder software and select “Setup” => “Communication Setting” => “System Channel”, In result, you can see the following dialog box. DVP-PLC Operation Manual 28