DeviceNet Network Scanner DVPDNET-SL 2.4 Address Switch are forbidden). The switch is used on setting up the node address of DVPDNET-SL on DeviceNet. Range: 00 ~ 63 (64 ~ 99 4 5 6 3 2 1 0 9 7 8 3 4 5 6 7 2 1 0 9 8 Example: If you need to set the node address of DVPDNET-SL to 26, simply switch the corresponding switch of x10 1 to 2 and the corresponding switch of x10 0 to 6. Note: z Please set up the node address when the power is switched off. After the setup is completed, re-power DVPDNET-SL. z When DVPDNET-SL is operating, changing the setting of node address will be invalid. z Use slotted screwdriver to rotate the switch carefully in case you scratch the switch.
2.5 Function Switch The function switches are for: „ Setting up the work mode (IN0) „ Setting up the baud rate of DeviceNet (DR0 ~ DR1) Note: z Please set up the function switch when the power is switched off. After the setup is completed, re-power DVPDNET-SL. z When DVPDNET-SL is operating, changing the setting of the function switch will be invalid. z Use slotted screwdriver to adjust the DIP switch carefully in case you scratch the switch. DVP-PLC Operation Manual 4 Switch setting Content 0 …
63 Valid DeviceNet node address 64…99 Invalid DeviceNet node address DR1 DR0 Baud rate OFF OFF 125kbps OFF ON ON OFF 250kbps 500kbps ON ON Entering the mode of extended baud rate ( see Chapter 9) When the slave is off-line, the I/O data in IN0 ON the buffer area will be held. OFF When the slave is off-line, the I/O data in the buffer area will be cleared. IN1 Reserved