７ Startup Procedure This section describes the procedure for connecting the NJ, various types of sensor amplifiers, and NA to use the E3NW-ECT Window. For the connection configuration, refer to 4-1 Device Configuration . ７ - １ Procedure Take the following steps to start the system. 6-2 Building the System Configuration Connect the NJ, sensor amplifiers, and NA with EtherNet cables. ↓ Connecting the NJ to sensor amplifiers Connect the NJ to each sensor amplifier via EtherCAT. ↓ Connecting the NJ to NA Connect the NJ to NA via the switching hub. ↓ Transfer the project file to the NJ and NA.
↓ Starting the Sysmac Studio and importing the project file Start the Sysmac Studio and import the project file. ↓ Checking the communication setting and executing the build Check the communication setting and program for project data and execute the build. ↓ Connecting online and transferring the project Connect the Sysmac Studio online and transfer the project data to the NJ and NA. ↓ Operating the screen After transferring the project data, check for normal operation of each screen. 47 6-3 Setting and Transferring the Project Data