4.5 Parameter monitoring mode After normal initialization, the system will automatically enter the status monitoring mode; press for once to switch to the parameter monitoring mode. The following figure shows operation of the keyboard in parameter monitoring mode to view partial information of previous warning (d0-12~d0-14 and d0-16). ● Upon selection of monitoring parameter dx-yz, please select a group number (x) first, and then select a number in the group (in case of yz, z can be carried over to y). ● The shift key controls rightward cyclical movement of the cursor on the first level interface in this mode; the position change follows the rule below:
LED0 (initial position)→LED3→LED1→LED0…, and it also controls alternative display of data on page 1 and page 2 on the second level interface in this mode. ● The monitored parameter values can be more efficiently viewed; in this mode, if the screen currently shows the second level interface, the key can be used to directly switch to the first interface of the next parameter (equivalent to pressing ); ● In this mode, when the first level interface is displayed, it can be directly switched to the second level interface for display by pressing the key can be used to directly switch to the first interface of the previous parameter (equivalent to pressing + ); the + key.
Otherwise they system will automatically enter the second level interface if no key operation occurs within 2s or a longer time. 41 Technical Manual for EA190 Series Servo Driver V100