1.3.2 Setup of the USB drivers for the Appliance Connection Kit After completing the installation of SidekickPC, there is another important installation that you must perform prior leaving the administrative mode in the PC: you must install the USB drivers for the Appliance Connection Kit. In order to perform this step you must have an Appliance Connection Kit (ACK) that Service Support Europe should have given you. You should connect the USB interface of the interface module to the PC by means of the supplied cable. The drivers are copied to the hard disk during the setup of SidekickPC in the USB Drivers directory starting from the installation folder. The default driver directory is:
C:\Electrolux\SidekickPC\USB Drivers You can find detailed instructions on how to setup the USB drivers in the “ Appliance Interface Modules USB Setup v 4.0” manual that is installed during the setup of SidekickPC. See the Application Note “ AN-Electrolux-CDM-Drivers-4.00.0-WIN10-WIN11-Installation-Issue for Win10/Win11 driver installation. © 2024 Electrolux Italia S.p.A., All rights reserved 12 File: SidekickPC.UserManual.EN.docx - Date: 15/04/2024 Classified as Internal