GTC – SOFTWARE DEVELOPMENT GROUP 1.3.2. Setup of the USB drivers for the Appliance Connection Kit After completing the installation of SidekickPC, there is another important installation that you must perform prior leaving the administrative mode in the PC: you must install the USB drivers for the Appliance Connection Kit. In order to perform this step you must have an Appliance Connection Kit (ACK) that Service Support Europe (SSE) should have given you. You should connect the USB interface of the interface module to the PC by means of the supplied cable.
The operating system recognizes that this is the first time that you connect the device to the PC and prompts you for the installation of the drivers. The drivers are copied to the hard disk during the setup of SidekickPC in the USB Drivers directory starting from the installation folder. The default driver directory is: C:\Electrolux\SidekickPC\USB Drivers You can find detailed instructions on how to setup the USB drivers in the “ Appliance Interface Modules USB Setup v 4.0” manual that is installed during the setup of SidekickPC.
Please remember that the sequence of operations that are required to install USB drivers varies a lot depending on the actual operating system and configuration of your PC. © 2012 Electrolux Italia S.p.A., All rights reserved 10 File: SidekickPC Manual (EN).pdf - Date: 20/04/2012