GTC – SOFTWARE DEVELOPMENT GROUP At the end of the automatic setup process, you can see the list of installed software packages: Fig. 2. Automatic setup: end of procedure There is the possibility that during the setup sometimes goes wrong. In order to help you solve setup problems Electrolux has documented all known setup issues and workarounds. You can find the solution for these problems here: http://sidekick.electrolux.com/SidekickPortal/UsersReservedArea/DownloadDetails.aspx?ContentID= ApplicationNote3 In case you have problems with the automatic setup procedure, you should try installing SidekickPC in a manual way.
Please refer to the Appendix for information concerning the manual setup. 1.3.1. Overriding the default installation folder If you want to install SidekickPC in an automatic way but not in the default folder ( C:\Electrolux\SidekickPC) , you can open the AutoInstall.cmd file with any text editor (such as, for example, Notepad) and change the following line: SET SK_DIR=C:\Electrolux\SidekickPC You should assign to the SK_DIR environment variable the full path of the target directory. For example, if you want to install the software in the D:\ driver instead of the C:\ one you can change the line in the following way:
SET SK_DIR=D:\Electrolux\SidekickPC Then you should save the file and quit the editor. Finally run the modified AutoInstall.cmd command as the previous paragraph describes. Please ensure that SK_DIR is assigned a valid folder name. © 2012 Electrolux Italia S.p.A., All rights reserved 8 File: SidekickPC Manual (EN).pdf - Date: 20/04/2012