7 TROUBLESHOOTING ACCORDING TO ALARM CODES Tests to be performed: Replace the circuit board and restart the diagnostic cycle to check for further alarm conditions. If there are traces of burning on the circuit board, refer to page 59 2007-10 SOI/DT-mdm FCPD-dp Quality-fz 18/59 599 70 32-47 E11: Difficulty in filling during wash phase E11 E11 Maximum water fill time for each pressure switch level (this time is reset to zero each time the level is reached) NO Access the diagnostic cycle and duct water through all the compartments (phases 2,3,4) Is water ducted through all the compartments? Do any or all the solenoids fail to function?
NO YES Is the ohmic resistance of the solenoid about 3.5 – 4.5 KΩ? (measure directly on the solenoid without wiring) -see fig. 3- NO YES Re-attach the connector and measure about 3.5 –4.5 KΩ on the solenoid wiring connector (circuit board side (fig.4): across J9-3 and J9-1 (washing), across J9.4 and J9.6 (prewash). Is the solenoid wiring OK? YES YES YES YES YES