Tests to be performed: Replace or repair the wiring and restart the diagnostic cycle to check for further alarm conditions. NO If there are traces of burning on the circuit board, refer to page 59 2007-10 SOI/DT-mdm FCPD-dp Quality-fz 20/59 599 70 32-47 E13: Water leakage E13 E13 Overall maximum water fill time exceeded (the sum of all the water fills between one drain phase and the next, to avoid exceeding the maximum volume) NO Access the diagnostic cycle and duct water through all the compartment (phases 2,3,4) Is water ducted through all the compartments? Do any or all the solenoids fail to function? YES Is the ohmic resistance of the solenoid about 3.5 – 4.5 KΩ?
(measure directly on the solenoid without wiring) -see fig. 3- YES Is the drain hose positioned correctly so as not to create the siphon effect? (fig.1) NO YES YES Is the hydraulic circuit of the pressure switch efficient (leaks/blockage)? fig.2 NO YES YES Re-attach the connector and measure about 3.5 –4.5 KΩ on the solenoid wiring connector (circuit board side) see fig. 4-: across J9-3 and J9-1 (washing) and across J9-6 and J9-4 (prewash). Is the solenoid wiring OK? YES Replace the circuit board and restart the diagnostic cycle to check for further alarm conditions.