9.5.8 Adjusting the dispenser levers a. Turn the timer knob to the start of a programme in which water is ducted through the washing compartment b. Check that the "1" is aligned with "b" on the dispenser. If not, lift pointer "2" and rotate the eccentric camme "3" until "1" is aligned with "b" (51) c. Turn the timer knob to a programme in which water is ducted through the conditioner compartment and check that the "1" is aligned with the "d" on the dispenser 51 9.5.9 Damper a. Remove the rear tub shell b. Press the locking key and at the same time remove the pin using pliers (52) c. Remove the damper from the support When re-assembling: Ц Check that the pin is not damaged; if so, replace it.
Ц Check that the anchor tabs protrude correctly. 9.5.10 Drum pulley a. Remove the rear tub shell b. Detach the drive belt from the pulley c. Block the pulley in position and remove the screw d. Remove the pulley 9.5.11 Pressure chamber a. Remove the rear cabinet shell b. Loosen the clamps and detach the pressure switch tubes from the pressure chamber c. Remove the screw (if present) d. Use pliers to widen the spring clip and detach the pressure chamber from the tub hose When re-assembling : Check that the pressure chamber is clean and secure the tubes and clips firmly in their original positions. SOI/DT 2002-05 eb 105 599 35 23-17