4 DIAGNOSTIC SYSTEM 4.1 Accessing diagnostics Do not start the procedure with the combination buttons pressed Serie 7 Serie 8 In the first position, the operation of the buttons, of the LEDs and the groups of symbols depicted on the LCD screen is checked; turn the programme selector dial clockwise to run the diagnostic cycle for the operation of the various components and to read any alarms. During this phase, if any key combination is pressed (except for the one relating to diagnostics), all the combinations of options stored are deleted (Extra rinse, No buzzer, etc..) whereas for SERIES 9, the memories with the customised programmes are also deleted.
4.2 Quitting the diagnostics system To exit the diagnostic cycle, switch the appliance off, then back on and then off again. A.D.L. 10 / 2010 7/26 599 73 54-08 Turn the appliance on at the ON/OFF switch and the first LED in the right-hand row is turned on. Press the START/PAUSE button and the nearest option button simultaneously (as shown in the figure). Hold the buttons/sensors down/pressed until the LEDs and symbols begin to flash in sequence (approximately 3 seconds).