Technician Handbook ! 673 Electronic & Computer Controlled Systems PicoScope Toolbars Scope Mode – Sets up PicoScope to operate as an oscilloscope. Use the Auto Setup button to optimize the settings. If you wish, you can add a secondary spectrum view from the context menu (by right-clicking on the scope view). Auto Setup – Searches for a signal on one of the enabled input channels, then sets up the timebase and signal range to display the signal correctly. Home – Restores PicoScope to its default settings. Equivalent to the File > Startup Settings > Load Startup Settings command.
Timebase Control – Sets the time represented by a single division of the horizontal axis when the horizontal zoom control is set to x1. The timebases available depend on the type of scope device you are using. Horizontal Zoom Control – Zooms the view, in the horizontal direction only, by the specified amount. Click the and buttons to adjust the zoom factor, or the button to reset. NOTE This information is available in PicoScope Help by searching for the word “timebase” in the index. Technical Training 47