User Guide of EM730 Series Inverter If the increment or decrement key on the keyboard is pressed, the function group and function code will not be modified, and the non-default function code following and in front of the current function code will be displayed respectively. If the displayed function code is modifiable currently in the Level 3 menu, the lowest bit indicated by the cursor will flicker. In this case, parameters can be modified in the Level 3 menu under the full menu mode. After modification, press the ENTER key to confirm and save the parameters and enable next non-default parameter. default values. Then enable the non-default mode. F00.03 will be displayed first.
When the For example, change F00.03 to 1 and F00.07 to 40.00 in the full menu mode, which are not potentiometer key on the keyboard is turned clockwise, F00.07 will be displayed; and when the potentiometer key on the keyboard is turned counterclockwise, F00.03 will be returned, as shown below: Flicker bit Flicker bit Flicker bit Flicker bit Fig. 4-4 Function Code Modification in Non-default Mode 4.3 Protection Monitoring When the inverter is in the protection status, you can directly press the right shift key to switch the current protection type and the output frequency, output current, output voltage, running status and working time during the protection. 35