User Manual of EM730/EM730E Series Inverter The digital output terminal Y1 and relay output terminal R1 have two output types: level and single pulse, as shown in Fig. 7-. For the level output, the output status of the function terminal is consistent with the function status; and for the single pulse output, the active level of a certain pulse width will not be outputted until the function is enabled. This function code is subject to bit operation. For specific settings, refer to the description of the function code F02.15. Table 7-7 Pre-output Valid Invalid Positive logic output Active level Inactive level Negative logic output Inactive level Active level Fig.
7-14 Schematic Diagram of Positive and Negative Logic Output of Digital Output Terminal The multi-function digital output terminal has two output logics according to the design: 0: Positive logic. When the function is enabled, the multi-function output terminal will output the active level; otherwise, the multi-function output terminal will output the inactive level. output the inactive level; otherwise, the multi-function output terminal will output the active 1: Negative logic. When the function is enabled, the multi-function output terminal will level. This function code is subject to bit operation. For specific settings, refer to the description of the function code F02.15.
Table 7-7 ★ This function is for logic matching with other external devices. Active level: Y1, low level by default; R1, high level by default. 172 Function Function code Default Parameter description Unit Attribute code name setting F03.06 Positive/ negative logic of digital output D7 D6 D5 D4 D3 D2 D1 D0 0*0 〇 * * * * * R1 * Y1 0: positive logic is valid in the closed state/invalid in the open state 1: negative logic is valid in the closed state/invalid in the open state