Epson Network Guide 4. Double-click Internet Protocol (TCP/IP) on the Local Area Connection Properties dialog box to open the Internet Protocols (TCP/IP) Properties dialog box. Set the IP address, the subnet mask, etc. and then click OK . 5. Restart the computer. The necessary components are now installed. Go to the section “Setting Up the Network Interface” on page 18. Mac OS To assign an IP address, subnet mask, etc. to your Mac, follow the steps below. 1. From the Apple menu, select System Preferences . 2. Open the Network control panel. Click the TCP/IP tab. Note:
For Mac OS X 10.6 or later, select Ethernet as the connecting method on the Network control panel, select the method to assign the IP address from the Configure menu, and then assign the IP address. 3. Select Built-in Ethernet from the Show pull-down menu. 4. Assign an IP address and other settings if necessary. 5. Click the Apply Now button to save any changes. Go to the section “Setting Up the Network Interface” on page 18. Setting Up the Network Interface Connecting the Network Interface to the Network Follow the instructions below to connect the network interface to the network. 1. Make sure that your printer is turned off. How To 18