1.1 Projector Specifications 6 mg/m3 or less. This is an approximate guide only and may change depending on the projector’s usage and surroundings.) *3 Light source brightness automatically dims if the surrounding temperature gets too high. (Approximately 40°C at an altitude of 0 to 2,286 m, and approximately 35°C at an altitude of 2,287 to 3,048 m; however, this may vary depending on the surrounding environment.) *2 The specifications are when the standard lens is attached. *4 All average values for this product at time of shipping comply with the ISO 21118 international standards.
*5 Based on Chinese national standard GB4943.1-2022 You can use a 100 V power cord to operate the projector temporarily to determine the installation location. Use the 200 V power cord when adjusting the projected image or the lens. When projecting using the 100 V power cord, the brightness of the projected image is approximately 60% compared to when using a 200 V power cord. You cannot use the following functions with the 100 V power cord. Light Source Mode Estimated Remains Refresh Mode Light Source Calibration Be sure to ground the power plug using a grounding wire or a 3-core power plug. Rev.A