DS-40 User’s Guide Getting to Know Your Product Interface Switches These switches are used to change the connection interface and the wireless connection setup. a. connection mode switch b. Connect button Note: ❏ Make sure the connection mode switch is set to the correct position before you start scanning. ❏ Do not move the connection mode switch when the product is operating. If you move the switch, scanning will be canceled. ❏ If you move the connection mode switch when the product is on, turn off the scanner, set the connection mode switch to the correct position, and then turn the scanner back on.
& “Problems Indicated by Status Light” on page 44 16 Parts Function Connection mode switch Change the connection interface. USB Set to USB when connecting with a USB cable. AP mode Set to AP mode when connecting using a direct Wi-Fi connection (access point mode). See Network Guide for more details. Wi-Fi Set to Wi-Fi when connecting using infrastructure mode. See Network Guide for more details. Connect button Use this when setting up a wireless connection. See Network Guide for more details on wireless setup.