■ Projector Parts - Interface 10 No. Name Note A Audio Out port (Stereo mini pin jack) O utputs audio from the current input source to an external speaker. B C Remote port (Stereo mini pin jack) a r onnects the remote control to the projector using the optional remote control cable set nd inputs signals from the remote control. When the remote control is connected, the emote receiver on the projector is disabled. C Cable holder P ass a commercially available cable tie through here to secure cables. D RS-232C port (Mini D-Sub 9-pin, male) U se to connect an RS-232C cable to control the projector from a computer.
E Service port (USB connector Type B) T his port is used for batch settings and firmware update. F T USB-A port (USB connector Type A) a his port is used for batch settings and firmware update. This projector can be powered t 5 V/2 A or 5 V/ 900mA. G U LAN port (RJ-45) T se a 100Base-TX or 10Base-T network cable. o ensure proper data transmission, use a Category 5 shielded cable or better. H Y u HDBaseT port (RJ-45) o T ou can use a network cable up to 100 m in length. To ensure proper data transmission, se a Category 5e STP cable or better. However, operation is not guaranteed for all input/ utput devices and environments. his port is compatible with HDCP2.3.
I I SDI In port (BNC) C nputs video signals from SDI compatible video equipment. (EB-PQ2010B/EB-PQ2010W/ B-PQ2010B only) O SDI Out port (BNC) P utputs video signals input from the SDI In port to an external monitor. (EB-PQ2010B/EB- Q2010W/CB-PQ2010B only) J I HDMI2 port (HDMI) T nputs video signals from HDMI compatible video equipment and computers. his port is compatible with HDCP2.3. (Audio is only supported by PCM) K I HDMI1 In port (HDMI) T nputs video signals from HDMI compatible video equipment and computers. his port is compatible with HDCP2.3. (Audio is only supported by PCM) L O HDMI1 Out port (HDMI) T utputs signals to an external monitor or another projector.
his port is compatible with HDCP2.3.