1.1 Projector Specifications 7 *1 Approximate time until the light source brightness decreases to half of its original value. (Assuming the projector is being used in an environment containing airborne particles of 0.04 mg/m3 or less. This is an approximate guide only and may change depending on the projector’s usage and surroundings.) *2 The specifications are when the standard lens is attached. *3 Light source brightness automatically dims if the surrounding temperature gets too high.
(Approximately 40°C at an altitude of 0 to 2,286 m, and approximately 35°C at an altitude of 2,287 to 3,048 m; however, this may vary depending on the surrounding environment.) *4 All average values for this product at time of shipping comply with the ISO 21118 international standards. This product is also designed for IT power distribution system with phase-to-phase voltage 230V. You can use a 100 V power cord to operate the projector temporarily to determine the installation location. Use the 200 V power cord when adjusting the projected image or the lens (EB‑PU2220B/EB‑PU2120W).
When projecting using the 100 V power cord, the brightness of the projected image is approximately 60% compared to when using a 200 V power cord (EB‑PU2220B/ EB‑PU2120W). You cannot use the following functions with the 100 V power cord (EB‑PU2220B/ EB‑PU2120W). Light Source Mode Estimated Remains Refresh Mode Be sure to ground the power plug using a grounding wire or a 3-core power plug. Light Source Calibration Rev.D