Network Guide Using Product via Network For information on setting up a Wi-Fi connection using the Wi-Fi Setup Wizard, click the following link. This feature is not available for all products or may not be enabled. html/wizard.htm Wi-Fi Protected Setup (WPS) There are two types of Wi-Fi Protected Setup (WPS); the WPS push button method, and the WPS PIN code method. These methods are available for products that do not have an LCD screen. Note: ❏ This setting is not available for all products or may not be enabled. ❏ If the access point (wireless router) is not discovered within approximately two minutes, an error message is displayed.
In that case, make sure the access point is operating, and then make the WPS settings again from the beginning. ❏ Before connecting the product to the network, check that the access point supports the WPS function. ❏ For details on the access point WPS function or troubleshooting, see the access point’s user’s guide. WPS push button You can setup by pushing the WPS button on a wireless router (access point). Use this method if you have already connected other Wi-Fi enabled devices using WPS. For information on setting up a Wi-Fi connection using the WPS setup, click the following link. This feature is not available for all products or may not be enabled.
html/wps_b.htm WPS PIN code You can setup by entering eight numbers to a wireless router (access point). The eight numbers are displayed on the product’s LCD screen or printed on the product’s network status sheet. For information on setting up a Wi-Fi connection using the WPS setup, click the following link. This feature is not available for all products or may not be enabled. html/wps_p.htm Direct Connection You can connect a product directly to a computer, smartphone, or tablet without a wireless router (access point). The following methods are available depending on your product and device. Wi-Fi Direct connection :
You can connect directly to the product using a Wi-Fi Direct compatible device. Even if your device does not support Wi-Fi Direct, you can connect the product to a device by using the product as an access point. This method uses the WPA2-PSK(AES) security method which is the same as infrastructure mode. “Wi-Fi Direct” on page 14 Ad Hoc connection : You can connect directly to the product using Ad Hoc compatible devices. This method only uses the WEP security method. “Ad Hoc mode” on page 15 13