^LH [Name] Set label home position [Format] ^LH x ,y [Function] Sets the home position, which is the basis for the print position. The home position is the origin point for the coordinate system which specifies the field origin point. The home position is specified as a position relative to the logical origin, based on Parameters x and y. The logical origin is the top-left corner of the printable area. The printable area refers to the area of the media used in printing, excluding the gap between labels and areas where printing cannot be performed due to the physical limitations of the printer.
The following figure indicates positioning of the logical origin, the home position, and the field origin. (The double white circle indicates the logical origin, the black circle indicates the home position, and the white circle indicates the field origin.) [Response] None [Note] If using this command, use it before defining the first field in the label format. [Reference] Related commands: None ESC/Label Command Reference Guide Rev.
L Page 172 Parameters Description Definition range x Home position x coordinate [dot] 0 ≤ x ≤ 32000 y Home position y coordinate [dot] 0 ≤ y ≤ 32000 The field origin is spec Gap between labels within the coordinate sets the home position x y X axis X Y Y axis Gap Gap ABC between between labels labels Printable area Gap between labels The field origin is spec within the coordinate sets the home position ified as (X,Y) system, which as (0,0). x y X axis X Y Y axis ABC Printable area X Y