^MF [Name] Set recover operation [Format] ^MF o ,s [Function] Sets the operation for when turning the power on and when changing the media. If C is specified for Parameter o or s, media calibration is performed. Media calibration is the same operation as “~JC”. If F is specified for Parameter o or s, label feeding to home position is performed. If L is specified for Parameter o or s, the media length is measured. If N is specified for Parameter o or s, feeding to home position is not performed. If S is specified for Parameter o or s, simple calibration is performed. Simple calibration performs the following operations. Adjustment of media sensor threshold values, etc.
Label feeding to home position Supported operations vary depending on the model. [Response] None [Reference] Related commands: None [Note] The ^JUS command is required to save settings to the non-volatile memory of the printer unit. Please refer to the “^JU” command section for details. [Usage example] An example of sending data that sets the operation for when turning the power on and when changing the media and saves settings to the non-volatile memory of the printer unit is shown below. ^XA ^MFN,S 1. Sets the power on operation to and the media change operation to . ^JUS 2. Saves the setting to non-volatile memory. ^XZ ESC/Label Command Reference Guide Rev.
L Page 177 Parameters Description Definition range o Power on operation o = C/F/L/N/S C: Calibration F: Feed L: Measure media length N: No feed S: Short calibration s Media change operation s = C/F/L/N/S C: Calibration F: Feed L: Measure media length N: No feed S: Short calibration