2.4.7 Print Area Settings Using ZPL II Commands ZPL II commands can be used to change some print area settings. These ZPL II commands and the corresponding print area settings are shown in Table 2.4.5. Table 2.4.5 ZPL II Commands for Setting the Print Area Adjustment of leading edge position of label (^LT) Label width specified with ^PW Figure 2.4.8 ZPL II Commands for Setting the Print Area The ^PW command specifies the sum of the left gap (mount) and label width. When the label width is specified with ^PW, the left gap is fixed and cannot be changed, and the value specified by ^PW minus the current left gap is set as the label width. ESC/Label Command Reference Guide Rev.
L Page 32 ZPL II command Function Print area setting ^LT Sets the vertical printing position adjustment. Adjustment of leading edge position of label ^PW Sets the label width Label width + left gap (mount) Paper Next label Maximum printable area Printable area Left ga p (mou nt) Label width