[Function] Sets the GS1 DataBar, the UPC, or the EAN barcode, or Composite symbol to the field. Sets the field orientation based on Parameter o. Sets the symbol type based on Parameter t. Sets the module size for symbol rendering based on Parameter m. Sets the height of separator based on Parameter s. Parameter s is enabled only when 1, 2, 3, 4, 5, 6, 11, or 12 is specified for Parameter t. Sets the height of barcode part of UCC/EAN-128 and CC-A/CC-B/CC-C based on Parameter h. Parameter h is enabled only when 11 or 12 is specified for Parameter t. The number of segments per line for GS1 DataBarExpanded is set based on Parameter n.
Parameter n is enabled only when 6 is specified for Parameter t. [Encoding] Composite symbols can be specified by including a vertical bar in the field data. In this case, Parameter t is set to the symbol type in the following table. If encoding a Composite symbol, a vertical bar in the field data is treated as a separator. Data before the vertical bar is encoded as barcode data, and data after the vertical bar is encoded as 2- dimensional code data. [Response] None [Reference] Related commands: ^FW ESC/Label Command Reference Guide Rev.
L Page 79 Value of Parameter t Symbol type 1 GS1 Standard and CC-A/CC-B 2 GS1 DataBar Truncated and CC-A/CC-B 3 GS1 DataBar Stacked and CC-A/CC-B 4 GS1 DataBar Stacked Omnidirectional and CC-A/CC-B 5 GS1 DataBar Limited and CC-A/CC-B 6 GS1 DataBar Expanded and CC-A/CC-B 7 UPC-A and CC-A/CC-B 8 UPC-E and CC-A/CC-B 9 EAN-13 and CC-A/CC-B 10 EAN-8 and CC-A/CC-B 11 UCC/EAN-128 and CC-A/CC-B 12 UCC/EAN-128 and CC-C