System Messages - Alphabetical List SAFE_UTL utility program or ACE every three months to re-commission the robot. If you have connected the robot to a different controller or replaced the controller or the SIO module, repeat the test. (For details, see the documentation for the SAFE_UTL program or the ACE User's Guide , and the hardware documentation for your robot.) Searching for string (exact case) (None) Explanation: The SEE editor command 0' has been entered. The editor is prepared to search for the string indicated, in the search mode indicated. User action: This is an informational message.
You can use the Repeat command to perform the indicated search, or you can use Find (or Change ) to initiate a new search (or replacement) operation. The EXACT extended command controls the setting of the search mode. Searching for string (ignoring case) (None) Explanation: The SEE editor command 0' has been entered. The editor is prepared to search for the string indicated, in the search mode indicated. User action: This is an informational message. You can use the Repeat command to perform the indicated search; or you can use Find (or Change ) to initiate a new search (or replacement) operation. The EXACT extended command controls the setting of the search mode.
*Servo board E-Stop fuse open* (-673) Explanation: Your servo board has a fused E-STOP circuit, and the system has detected an open circuit at that location. User action: Refer to your hardware documentation, consult with Omron Adept Customer Service as needed for details about types and locations of fuses, and replace the fuse. *Servo board 12v fuse open* (-671) Explanation: Your servo board has a fused 12-volt bus, and the system has detected an open circuit at that location. User action: Refer to your hardware documentation, and replace the fuse. *Servo board solenoid fuse open* (-672) Explanation:
Your servo board has a fused robot solenoid control line, and the system has detected an open circuit at that location. User action: Refer to your hardware documentation, and replace the fuse. eV+Language Reference Guide, v2.x, 18319-000 Rev A Page 648