ID monitor command ID monitor command Syntax ID Function Display identity information about components of the system. Details When the ID command is issued, the following information is displayed: l If a user-defined startup message has been defined, that message is displayed. Details of the ID information are given below. The option words contain coded information about the system (formatted as hexadecimal values). This information is useful to Omron Adept support personnel when troubleshooting your system. NOTE : For detailed information on the option words, see ID option words. Output for ID: Software: .
- ( message>) version the eV+ version number, which is the same value that is returned by the function ID(3). revision the eV+ revision number, which is the same value that is returned by the function ID(4). opt1 the system option word 1, which is the same value that is returned by the function ID(5). opt2 the system option word 2, which is the same value that is returned by the function ID(6). ID message the identifying string, which is the same value that is returned by the function $ID(-1). Controller: - model the controller model number, which is the same value that is returned by the function ID(1).
serial the controller serial number, which is the same value that is returned by the function ID(2). revision the controller hardware revision/ID, displayed as a hexadecimal value. (This value is returned by the function ID(10).) options the controller option word, which is the same value that is eV+Operating System Reference Guide, 2.x,18321-000 Rev A Page 107