STORE monitor command STORE monitor command Syntax STORE /levels file_spec = program, ..., program Function Store programs and variables in a disk file. Usage Considerations STORE can be used while a program is executing, and an executing program can be stored. There must be sufficient room on the disk to hold the new disk file. Otherwise, the store operation will fail. Loading and storing precision points on a system with less axes than the one which defined them will result in components being lost. Protected and read-only programs in memory cannot be stored.
Parameters /levels Optional qualifier that determines the level of program references to consider if a "program" parameter is specified. If the qualifier "/levels" is omitted, all program references are processed as described below. If the qualifier is specified as "/2", for example, only the first two levels of program references are processed. file_spec Specification of the disk file into which the programs and variables should be stored. This consists of an optional physical device, an optional disk unit, an optional directory path, a file name, and an optional file extension. The current default device, unit, and directory path are considered as appropriate (see the DEFAULT command).
If no filename extension is specified, the extension ".V2" will be appended to the name given (for disk files only). program Optional name of a program in memory. Details This command creates the specified disk file and stores the following information in the file: eV+Operating System Reference Guide, 2.x,18321-000 Rev A Page 167