STOREP monitor command STOREP monitor command Syntax STOREP /levels file_spec = program, ..., program Function Store programs to a disk file. Usage Considerations STOREP can be used while a program is executing. There must be sufficient room on the disk to hold the new disk file. Otherwise, the store operation will fail. Protected and read-only programs in memory cannot be stored. In general, it is good programming practice to group programs into modules, so STOREM should normally be used instead of STOREP. Parameters /levels Optional qualifier that determines the level of program references to consider if a "program" parameter is specified.
If the qualifier "/levels" is omitted, all program references are processed as described below. If the qualifier is specified as "/2", for example, only the first two levels of program references are processed. file_spec Specification of the disk file into which the programs should be stored. This consists of an optional physical device, an optional disk unit, an optional directory path, a file name, and an optional file extension. The current default device, unit, and directory path are considered as appropriate (see the DEFAULT command). If no filename extension is specified, the extension ".PG" will be appended to the name given (for disk files only).
program Optional name of a program in memory. eV+Operating System Reference Guide, 2.x,18321-000 Rev A Page 173