Using Directories The Current Directory When you are working exclusively within a single subdirectory, it is inconvenient to specify the full path for every file operation. The CD command specifies a default path to use with all subsequent commands. To make DATA_1 the default (current) directory, enter the command: CD D:\PROGS_2\DATA_1 ↵ The following figure shows the effect of the above command. Default Directory Specification After the above default path has been set, the command: LOAD my_file.v2 ↵ will load the copy of "my_file.v2" that is in the subdirectory "DATA_1" rather than the copy in the root directory. You can also change relative to the current directory with the CD command.
If the current directory is D:\PROGS_2 and you enter the command: CD DATA_1 ↵ The current directory will change to D:\PROGS_2\DATA_1. If you now enter the command: eV+Operating System User's Guide, v2.x, 18320-000 Rev A Page 42