4.1.2 Basic operation of the operation panel Basic operation 1 2 Faults history *2*3 Monitor *1 Operation mode switchover *4 Output frequency monitor (At power-ON) Output current monitor Output voltage monitor 3 4 (Example) (Example) (Example) Blinking Blinking Blinking 5 Faults history 1 Faults history Faults history 2 Faults history 8 6 7 External operation mode (At power-ON ) PU operation mode 8 PU Jog operation mode 9 Pressing the MODE key while in the "P. 0" screen returns to the monitor screen. Pressing the SET key while in any of the screens above will change to the parameter setting screen.
10 Parameter setting *5 Parameter setting mode Display the present setting Alternate display (Example) Change the setting. Parameter write is completed!! Calibration parameter Parameter clear All parameter clear Faults history clear Group parameter setting Initial value change list *1 The monitor items can be changed. (Refer to page 124 .) *2 For the details of each fault, refer to page 211 . *3 In each fault record display, "0" is displayed instead of the fault indication when no fault record exists. *4 For the details of operation modes, refer to page 100 . *5 "P. 0" will appear if the MODE key is pressed during parameter setting. 67 4. BASIC OPERATION 4.1 Operation panel