CHASSIS MODIFICATIONS 2-31 E UROCARGO Euro 4/5 Figure 2.12 Version for chassis with long overhangs Version for chassis with short overhangs 1. Original rear cross member - 2. Connecting angle piece - 3. Connecting plate - 4. Gusset plate - 5. Pressed steel channel sections (same size as chassis) - 6. Space for rear sprung support 91457 Assurance should be given that the movements between the tow bar and vehicle conform to current regulations. As a general rule, the original towable mass can be confirmed by IVECO. In any event the responsibility for the work carried out will rest with the bodybuilder. The vehicle must be presented for inspection if local government regulations require it.
In Figure 2.12 shows an example of a lowered supplementary cross member. When this solution is applied to short rear overhang vehicles, the external connecting plates must conform to the arrangement described in Figure 2.12. Should the brackets of the underrun bar be modified, following the lowering of the rear cross member, the new version will be equivalent to the original in terms of attachment, strength and stiffness and the positioning of the lights checked for compliance with the standards (local standards where applicable). Installing a towing device Print 603.93.431 Base - January 2008