To Reinstall: 1 Replace the Anticurl Strings into the pulleys on the ends of the Delivery Head Assembly. 2 Reinstall the Delivery Head Assembly onto its elevator mounts and secure it with the screws. Make sure that the locating pins are in place. 3 Replace the Tension Springs on the Anticurl Strings at the bottom of the frame with the T-10 Torx screws (Figure 6-168, callout 2). 4 Snap the Anticurl Strings into the pulleys at the bottom of the frame (Figure 6-168, callout 3). 5 Reconnect the flat ribbon cable to the Delivery Head Assembly, and secure the cable to the frame with the cable clip (Figure 6-169, callouts 4 and 5).
6 Make sure that the Delivery Head Assembly moves up and down freely. 354 Chapter 6 Removal and Replacement C4085-91087