Table 7-6. Engine Error Messages (continued) 408 Chapter 7 Troubleshooting C4085-91087 Control Panel Message Event Log Error Message Description Recommended Action 50.x FUSER ERROR Critical Error A fuser error has occurred. X Description 1 Low Fuser temperature. 2 Fuser warm up service. 3 High Fuser temperature. 4 Faulty Fuser. 5 Inconsistent Fuser. Turn the printer off for at least 20 minutes, and then turn the printer on. If the error continues: 1. Make sure that the Fusing Assembly is installed correctly and is fully seated into its connectors (no bent pins or pins outside their receptacles). 2. Reseat or replace the fuser cable assembly. 3. Replace the DC Controller.
51.x PRINTER ERROR Error A temporary printing error occurred. X Description 1 Beam detect error. 2 Laser error. 1. Press GO. The page containing the error will automatically be reprinted. 2. Turn the printer off, and then turn the printer on. 3. Reseat the cables. See the wiring diagrams at the back of this manual. 4. Replace the Laser/Scanner. See “Laser/Scanner Assembly” on page 200 for instructions. 52.x PRINTER ERROR Error A temporary printing error occurred. X Description 0 Laser/scanner error. 1 Laser/scanner startup error. 2 Laser/scanner rotation error. 1. Press GO. The page containing the error will automatically be reprinted. 2. Turn the printer off, and then turn the printer on.
3. Reseat the cables. See the wiring diagrams at the back of this manual. 4. Replace the Laser/Scanner. See “Laser/Scanner Assembly” on page 200 for instructions.