beckhoff TF5200 — 2.3 Positions off set

Description 2.3 Positions off set The link between a physical and a logical axis can be changed by an active program with the axes at standstill. After axis output is suspended, the axes can be moved by another channel. After an axis is returned to the original channel, the commanded position in the channel (command position) and the physical position (active position) may be different. This position offset is cleared at program start and with NC commands (such as #CHANNEL INIT[], deselection of G200 etc.) which cause a position adjustment in the channel.

Therefore, the commanded position in the channel corresponds to the physical set position of the axis (command position = active position). The position offsets of the axes are cleared when the channel is initialised or at program start. Offset = command position (of active link) – active position Logical axis of channel 2 1 (drive) Fig. 5: Position offset by another channel TF5200 | TwinCAT 3 CNC Jog of path 15 Version: 1.17 Channel Channel 1 2 Original Jog of program path 1 11 Command Com position positi 1 Channel 2 Jog of path 11 Com positi Active position Position controller