Parameter 5 Parameter 5.1 Overview 5.2 Description Channel parameters Axis parameter TF5200 | TwinCAT 3 CNC Jog of path 21 Version: 1.17 ID Parameter Meaning P-AXIS-00040 kopf.clone of _ Axis copy P-AXIS-00101 kopf.link to _ Link to the physical axis P-AXIS-00483 kenngr.auto release o _ _ f axis link _ _ Enabling of IPO-LR interface after axis release P-CHAN-00306 jog of path only _ _ _ License check of the clone channel P-CHAN-00306 Checking the license in the clone channel Description This parameter checks the license in the clone channel. When this parameter is set, a check is made during start-up whether all the axes configured in the channel are clone axes.
Only then is this channel license-free. The check is also made at RESET and axis exchange. If an axis is not a clone axis, an error message is output. Parameter jog of path only _ _ _ Data type BOOLEAN Data range 0/1 Dimension ---- Default value 0 Remarks This parameter allows the 2nd channel to be used as a Jog-Of-Path channel even with a single-channel license. The parameter is available as of Build V3.1.3037.17. P-AXIS-00040 Mapping of parameters of an existing axis for default configuration. Description For easier configuration, an axis could be a copy (clone) of another axis. This means, when the axis is initialised, the clone just uses the data of its master as template.
The clone merely has to specify the differences to its master in the parameter list. Parameter kopf.clone of _ Data type UNS16 Data range 0 Axis types T, R, S Dimension T: ---- R,S: ---- Default value 0 drive types. ---- Remarks P-AXIS-00101 Linking an interpolator output to a specific physical axis. Description The parameter requests a link between the logical axis of the interpolator and the axis of the position controller (drive). If you attempt to link more than one logical axis to the same drive, all the other axes must wait until this link is temporarily interrupted by a command and released for a new connection. Parameter kopf.link to _