5. Applicable Devices and Device Configuration Precautions for Correct Use section or higher versions using the auto update function. Update the CX-Programmer and Network Configurator to the versions specified in this If a version not specified in this section is used, the procedures described in Section 7. and subsequent sections may not be applicable. In that case, use the equivalent procedures described in this document by referring the CX-Programmer Operation Manual (Cat. No. W446) and Network Configurator Online Help. Additional Information For specifications of the 24 VDC power supply available for the Switching hub, refer to the Switching Hub W4S1-series User's Manual (Cat. No.
0969584-7). Additional Information For specifications of the 24 VDC power supply available for the FZ5 Sensor Controller, refer to the Image Processing System Instruction Sheet (Cat. No. 9524422-4/ 9910002-2). Additional Information For specifications of the 24 VDC power supply available for the Monitor, refer to the LCD monitor Instruction Sheet (Cat. No. 1636843-6). Additional Information The system configuration in this document uses USB for the connection between the Personal computer and PLC. For information on how to install the USB driver, refer to A-5 Installing the USB Driver of the CJ-series CJ2 CPU Unit Hardware User's Manual (Cat. No. W472). 7