Mounting the Device on a Roll Bar 1 Using a flat-head screwdriver or 9 / 32 -in. (7-mm) nut driver, loosen the bolt on the roll bar mount until the ring separates. 2 Place the mount around the roll bar. 3 Tighten the bolt on the mount until the ring is secure. 4 Insert the ball on the Group Ride mount into the double-socket arm . 5 Tighten the knob slightly. 6 If necessary, rotate the Group Ride mount so that the Garmin logo faces up and adjust the mount for better viewing and operation. 7 Tighten the knob to secure the mount. 8 Press the device into the Group Ride mount until it snaps into place. 9 Connect the Group Ride power cable to the connector on the vehicle wiring harness.
10 Tighten the collar around the connected power cables. 11 Route the power cable along a suitable path in your vehicle and secure it using the included zip ties. Installation 5