Connector View (8700 models) Tips and Shortcuts (MFD models) Press to turn on the chartplotter. From any screen, press repeatedly to scroll through the brightness levels, if available. This can be helpful when the brightness is so low you cannot see the screen. Select from any screen to open to the home screen. Select Options to open additional settings about that screen. Select Toolbars to quickly add a toolbar overlay to the current page. Select to close the menu when finished. Press to open additional options, such as adjusting the backlight. Press , and select Power > Turn Off System , or hold until the Turn Off System bar fills to turn off the chartplotter, when available.
1 Only compatible Garmin card readers recommended. Third-party card readers are not guaranteed to be fully compatible. 16 GPSMAP® 8400/8600/8700 Series Owner's Manual Introduction HDMI OUT HDMI out CVBS IN Composite video in NMEA 0183 NMEA® 0183 and audio out USB Micro-USB to connect a compatible Garmin card reader, or to connect and control a computer using the chartplotter touchscreen NMEA 2000 NMEA 2000® network ENGINE/J1939 J1939 engine network POWER Power cable connection NETWORK Garmin® Marine Network HDMI IN HDMI® in HDMI OUT HDMI out to connect the chartplotter to a monitor. Required for device functionality.
CVBS IN Composite video in 1 Status LED Power ground Power button NMEA 0183 NMEA® 0183 and audio out USB HOST Micro-USB output for connecting a touchscreen monitor USB OTG Micro-USB input from compatible Garmin card reader1, computer, or other supported USB accessory NMEA 2000 NMEA 2000® network J1939 J1939 network