G etting S tarted > U nit O verview Transferring Data to a microSD Card Some units are equipped with a pre-installed microSD card. Other units configured for use in large geographic regions (eg. Pacific) require a much larger capacity microSD card to store enough map data (not provided). 2. Connect the USB cable provided with the unit to the USB port on your PC and to the mini- USB port on the back of the unit. 3. Follow instructions for selecting and downloading maps provided with the MapSource map data disk and Help files. To install or remove the microSD card: USB Port (under weather USB Port (under weather 1.
Remove the Battery Compartment Cover from the back of the unit and remove the batteries. cover) cover) 2. Locate the card tray at the center of the battery microSD card tray is located beneath the batteries in the battery compartment. microSD card tray is located beneath the batteries in the battery compartment. compartment and check to be certain the card is installed in the tray. 3. To remove the card, slide the tray cover up, then lift it toward you to remove the card from the tray. Slide the tray cover back to Slide the tray cover back to OPEN, then lift to remove or insert the microSD card. OPEN, then lift to remove or insert the microSD card. 4.
To re-insert the card, lay the card in the tray, Close and slide forward to Close and slide forward to close the tray, and replace the batteries and cover when finished. LOCK. LOCK. To transfer map data to the microSD card: 1. Lift the weather cover from the USB port on the upper back of the unit. It recommended that you use the USB port rather than the Serial Connection port for faster data transfer. Detail of microSD card Detail of microSD card tray tray Back of GPSMAP 60CSx (with Battery Back of GPSMAP 60CSx (with Battery Cover removed) Cover removed) GPSMAP 60CSx Owner’s Manual 9 Unl Lo