Fusing element 1 Remove the DIMMs, the back, right, and left covers, the internal paper guide, and the top cover (see pages 89 through 95). 2 Also remove the output roller and the delivery assembly (see pages 114 through 117). Note Pay special attention to the way these metal clips are attached to the printer chassis before you remove them. This will make reassembly easier. The fusing element is held in place on each end by two metal spring- loaded clips. Each clip has a small white lever next to it. These levers must be in the “up” position. 3 Push each clip down and back, releasing it from the printer chassis. Figure 46. Fusing element removal (1 of 4) EN Internal assemblies 119