NVRAM init NVRAM init sets all default variables stored in NVRAM back to factory default values or to a default ROM value, depending on the variable, and performs a system reset. NVRAM init resets the following: all menu settings to factory default values including fax header and company name factory settings such as formatter number, page counts, and factory paper settings fax memory—all faxes in memory are erased To perform NVRAM init 1 Unplug the product from the power source. 2 Press and hold down the S YMBOLS key and E NTER /M ENU . 3 Continue to hold down the keys while you plug back in the product, through the entire power on sequence.
4 When both of the control panel LEDs light up, release the keys. PERMANENT STORAGE INITIALIZE should appear on the control panel display. PJL software commands To set the following NVRAM variables: Factory printer DEFAULT PAPER, scanner factory default paper size will be set to the same value automatically. Factory printer DEFAULT LPARM:PCL SYMSET Factory DEFAULT OEM bit Factory DEFAULT PRINTPAGECOUNT Factory DEFAULT SCANPAGECOUNT Factory DEFAULT COPYPAGECOUNT Note Default quick copy paper size is also stored in scanner NVRAM but is changed only through the software or when set back to factory default with a NVRAMINIT.
Only quick copy image type and contrast have a default value stored in NVRAM; they can only be changed through the software or by NVRAMINIT, which returns them to a ROM default value. 178 Chapter 6 - Troubleshooting EN