Recalibrating the scanner The HP LaserJet 3200 product was calibrated at the factory. However, you might have to recalibrate the scanner if you notice that sent faxes, copies, or items scanned to the computer have black or white lines running through them. 5 To recalibrate the scanner 1 Clean the HP LaserJet 3200 product before recalibrating it. (See “Cleaning the product” on page 54 and “Cleaning the scanner path” on page 57.) 2 On the control panel, press E NTER / M ENU . 3 Press the button once to display SERVICE and press E NTER /M ENU . 4 Use the and > buttons to select SCAN CALIBRATION and press E NTER / M ENU .
5 Insert a blank, bright white piece of letter (8.5 by 11 inches or 216 by 279 mm) or A4 (8.3 by 11.7 inches or 210 by 297 mm) paper into the document feeder tray. 6 Press E NTER /M ENU to begin the recalibration. 7 The product pulls the piece of paper through and then prints a recalibration test page. Discard this page. The recalibration procedure is complete. 8 For information about interpreting the recalibration test page, see “Document scanner recalibration” on page 192. EN Recalibrating the scanner 59 7