Removal Procedure Warning ！ Refer to "Warnings regarding battery disconnection" in " Warnings and Precautions ". 1 Open the engine compartment hood. 2 Disconnect the negative cable of battery, refer to Procedures for disconnecting and connecting battery cable . 3 Remove the engine trim cover assembly, see Replacement of Engine Trim Cover Assembly . 4 Remove the air filter assembly, see Replacement of Air Filter Assembly . 5 Remove the air filter intake pipe assembly. refer to Replacement of air filter intake pipe assembly .
6 Disconnect the harness connector A of the air conditioning coolant temperature sensor (cylinder head), and remove the air conditioning coolant temperature sensor (cylinder head). Installation Procedure KX11 PHEV 2023 Engine Engine control system (DHE15-ESZ) 2-45 1 Install and fasten the air conditioning coolant temperature sensor (cylinder head). Torque: 15N·m Caution 1. It is prohibited to touch the part pins. 2. Electrical plugging or unplugging of part connectors is not permitted during energizing operations such as cold or hot test. 3. Avoid dropping parts or subjecting them to shocks. Dropped parts must be scrapped. 4.
If replace the sensor necessarily with a new one, check that there is no obvious deformation or damage on the threads of the installation holes, and then install a new sensor according to the specified torque. 5. If the sensor is reused, clean the residual glue inside the sensor mounting holes, check that the