Warning ！ Refer to "Warnings regarding battery disconnection" in " Warnings and Precautions ". 1 Open the engine compartment hood. 2 Disconnect the negative cable of battery, refer to Procedures for disconnecting and connecting battery cable . 3 Remove the engine trim cover assembly, see Replacement of Engine Trim Cover Assembly . KX11 PHEV 2023 Engine Engine control system (DHE15-ESZ) 2-31 4 Disconnect the harness connector A of the electric motor coolant valve. 5 Remove the three fixing screws 1 of the electric motor coolant valve, and take off the electric motor coolant valve.
Installation Procedure 1 Install the electric motor coolant valve and tighten the three fixing screws 1 of the electric motor coolant valve. Torque: 10N·m Caution 1. Make sure that the electric motor coolant valve is positioned correctly, and then screw in the three fixing screws in turn. 2. Before assembly, take care to check the rubber sealing ring of the electric motor coolant valve (A) for detachment/foreign material attachment to ensure sealing. 2 Connect the harness connector A of the electric motor coolant valve. 3 Install the engine trim cover assembly. 4 Connect the negative cable of battery. 5 Use the GLDS diagnostic program.
On the [Software] tab, select the corresponding module and follow the steps prompted by the diagnostic program to complete the 6 Close the engine compartment cover. software flash operation.